24
2023
-
07
Common troubleshooting methods for glass bottle capping machines
Author:
Administration Department – Li Yuanyuan
First, the inspection method for checking whether the equipment cylinder piston is not functioning:
1. Confirm that the emergency stop switch is safe.
2. Confirm whether the gas source switch is turned on.
3. Confirm whether the one-way signal valve is damaged.
Second, after the equipment cylinder piston reaches the top dead center and fails to return, you need to confirm whether the moving target is in contact with the check valve.
Third, the inspection method for checking whether the equipment’s filling volume is inaccurate or whether it fails to dispense material.
1. Confirm whether the upper and lower throttling valves are closed.
2. Increase the material extraction speed by increasing the throttle valve opening of the cylinder.
3. Confirm whether the quick-connect tee is locked in place with a clamp.
4. Confirm whether the material hopper has sufficient material.
5. Confirm that the individual pipe connections are sealed.
Fourth, when the material from the equipment flows out from the rear end of the料缸, these two aspects should be checked:
1. Check whether the sealing ring on the piston is worn; if it is worn, replace it.
2. Confirm that the piston and piston rod are securely fastened.
The previous one
Filling solutions for multiple industries
Address:
No. 1921, Shibalijie (formerly Dongjing Road), Economic Development Zone, Qingzhou City, Shandong Province
Phone:
Email:
Online mall:
Mobile Site